YOU BUY 1% OF THE BUILDING MATERIALS, BUT WE ENSURE YOU 100% OF QUALITY ASSURANCE AND SERVICE COMMITMENT
 |
HEXIE ANCHOR
Blister Packing / Plastic Kits
Heavy Duty
Plaster, Wallboard, Concrete Block or Hollow Tile
The nylon clip toggle anchor is a heavy duty hollow wall anchor designed for use in base materials such as plaster, wallboard, concrete block or hollow tile. The nylon clip toggle anchor is a pre-assembled anchor consisting of a carbon steel wing and a locking cap/ratchet leg assembly molded from engineered plastic. It is available in 3/16", 1/4", 3/8" and 1/2" sizes. When compared to traditional toggles, this unique anchor can be installed in a smaller hole and does not require a fixture or screw to set it. The anchor can be easily adjusted to accommodate a wall thickness of up to 2 1/2" while using a shorter bolt. The bolt and fixture may be installed and removed as often as necessary.
Item Code | NCT001 | NCT002 | NCT003 | NCT004 |
SIZE | 3/16" | 1/4" | 3/8" | 1/2" |
INSTALLATION
 | ||||
Drill the proper size hole into the cavity of the hollow base material. | Position the wing parallel to the plastic legs and slide the anchor through the drilled hole into the hollow cavity | Pull the wing firmly against the inside wall of the hollow material using the ring, then slide the plastic cap forward until the flange is seated flush against the work surface. | Place your thumb between the plastic straps and snap the straps off. | Position the fixture. Insert the bolt through the fixture and tighten. The minimum bolt length should be at least 1/2" longer than the combined wall and fixture thickness. |
The nylon clip toggle anchor is a heavy duty hollow wall anchor designed for use in base materials such as plaster, wallboard, concrete block or hollow tile. The nylon clip toggle anchor is a pre-assembled anchor consisting of a carbon steel wing and a locking cap/ratchet leg assembly molded from engineered plastic. It is available in 3/16", 1/4", 3/8" and 1/2" sizes. When compared to traditional toggles, this unique anchor can be installed in a smaller hole and does not require a fixture or screw to set it. The anchor can be easily adjusted to accommodate a wall thickness of up to 2 1/2" while using a shorter bolt. The bolt and fixture may be installed and removed as often as necessary.
Item Code | NCT001 | NCT002 | NCT003 | NCT004 |
SIZE | 3/16" | 1/4" | 3/8" | 1/2" |
INSTALLATION
| ||||
Drill the proper size hole into the cavity of the hollow base material. | Position the wing parallel to the plastic legs and slide the anchor through the drilled hole into the hollow cavity | Pull the wing firmly against the inside wall of the hollow material using the ring, then slide the plastic cap forward until the flange is seated flush against the work surface. | Place your thumb between the plastic straps and snap the straps off. | Position the fixture. Insert the bolt through the fixture and tighten. The minimum bolt length should be at least 1/2" longer than the combined wall and fixture thickness. |
