YOU BUY 1% OF THE BUILDING MATERIALS, BUT WE ENSURE YOU 100% OF QUALITY ASSURANCE AND SERVICE COMMITMENT
 |
HEXIE ANCHOR
Blister Packing / Plastic Kits
Heavy Duty
Block, Wallboard and Other Hollow Base Materials
The toggle bolt is a spring wing type hollow wall anchor designed for use in block, wallboard and other hollow base materials. The toggle bolt is a twopart assembly consisting of a machine screw and a spring wing toggle. Sizes range from 1/8" diameter x 2" length to 1/2" diameter x 6" length with combo round, flat mushroom, tie-wire or slotted hex head styles.
• Adjustable to accommodate various wall thickness up to 2 1/2"
• Easy to use and works in a variety of base materials
Size | Drill Hole | Pull out load kgs |
1/8" or M3 | 3/8"-10mm | 130 |
M4 | 1.5mm | 150 |
3/16" | 1/2" | 200 |
M5 | 14.5mm | 200 |
1/4", or M6 | 5/8"-16mm | 500 |
5/16" or M8 | 7/8" | 500 |
3/8", orM10 | 7/8" | 550 |
1/2", or M12 | 1-1/4" | 680 |
INSTALLATION
 | ||
Drill the required hole through the base material. The tolerances of the drill bit used should meet the requirements of ANSI Standard B212.14. In denser materials such as high strength concrete, drill the hole 1/16" larger. | Insert the bolt through the fixture to be fastened, thread on wings, then fold the wings completely back and insert through the hole until wings spring open. | Pull back on assembly to hold the wings inside the wall to prevent the wings from spinning while tightening bolt. Turn the bolt with the screwdriver until firmly tightened. |
The toggle bolt is a spring wing type hollow wall anchor designed for use in block, wallboard and other hollow base materials. The toggle bolt is a twopart assembly consisting of a machine screw and a spring wing toggle. Sizes range from 1/8" diameter x 2" length to 1/2" diameter x 6" length with combo round, flat mushroom, tie-wire or slotted hex head styles.
• Adjustable to accommodate various wall thickness up to 2 1/2"
• Easy to use and works in a variety of base materials
Size | Drill Hole | Pull out load kgs |
1/8" or M3 | 3/8"-10mm | 130 |
M4 | 1.5mm | 150 |
3/16" | 1/2" | 200 |
M5 | 14.5mm | 200 |
1/4", or M6 | 5/8"-16mm | 500 |
5/16" or M8 | 7/8" | 500 |
3/8", orM10 | 7/8" | 550 |
1/2", or M12 | 1-1/4" | 680 |
INSTALLATION
| ||
Drill the required hole through the base material. The tolerances of the drill bit used should meet the requirements of ANSI Standard B212.14. In denser materials such as high strength concrete, drill the hole 1/16" larger. | Insert the bolt through the fixture to be fastened, thread on wings, then fold the wings completely back and insert through the hole until wings spring open. | Pull back on assembly to hold the wings inside the wall to prevent the wings from spinning while tightening bolt. Turn the bolt with the screwdriver until firmly tightened. |
