Cixi Bill Fastener Factory

> Plastic Conical Anchor

> Plastic Toggle Anchor

> Plastic Hollow Wall Anchor

> Nylon Nail Anchors

> Cable Clips

> Speed Plug (Nylon)

> Fishlike Anchor (PE or Nylon)

> Split Ribbed Plastic Anchor

> Super Ribbed Plastic Anchor

> Extruded Plastic Plug

> Nylon Frame/Hammer Fixing

> Split Drive Anchors

> Heavy Duty Shield Anchor

> Tie Wire Anchor

> Blister Packing

> Plastic Box

TOGGLE BOLT

DESCRIPTION

The toggle bolt is a spring wing type hollow wall anchor designed for use in block, wallboard and other hollow base materials. The toggle bolt is a two-part assembly consisting of a machine screw and a spring wing toggle. Sizes range from 1/8" diameter x 2" length to 1/2" diameter x 6" length with combo round, flat mushroom, tie-wire or slotted hex head styles.
• Adjustable to accommodate various wall thickness up to 2 1/2"
• Easy to use and works in a variety of base materials

SPECIFICATIONS

Size	Drill Hole	Pull out load kgs
1/8” or M3	3/8” -10mm	130
M4	1.5mm	150
3/16”	1/2”	200
M5	14.5mm	200
1/4”, or M6	5/8”-16mm	500
5/16” or M8	7/8”	500
3/8”, or M10	7/8”	550
1/2”, or M12	1-1/4”	680

INSTALLATION

Drill the required hole through the base material. The tolerances of the drill bit used should meet the requirements of ANSI Standard B212.14. In denser materials such as high strength concrete, drill the hole 1/16" larger.

Insert the bolt through the fixture to be fastened, thread on wings, then fold the wings completely back and insert through the hole until wings spring open.

Pull back on assembly to hold the wings inside the wall to prevent the wings from spinning while tightening bolt. Turn the bolt with the screwdriver until firmly tightened.