> Plastic Conical Anchor > Plastic Toggle Anchor > Plastic Hollow Wall Anchor > Nylon Nail Anchors > Cable Clips > Speed Plug (Nylon) > Fishlike Anchor (PE or Nylon) > Split Ribbed Plastic Anchor > Super Ribbed Plastic Anchor > Extruded Plastic Plug > Nylon Frame/Hammer Fixing > Toggle Bolt > Wedge Anchor > Hollow Wall Anchor > Wall Board Anchor > Sleeve Anchor > Stud Anchor > Drop In Anchors > Split Drive Anchors > Heavy Duty Shield Anchor > Tie Wire Anchor > Blister Packing > Plastic Box

PLASTIC HOLLOW WALL ANCHOR   DESCRIPTION The plastic hollow wall anchor is a screw actuated hollow wall anchor for use in paneling, wallboard, and solid masonry. The plastic hollow wall anchor is available in 6 sizes to match the most common wall thicknesses of hollow base materials. In solid base materials, the anchor can be used by removing the outer wings.   SPECIFICATIONS Dimension Anchor Size Mini Short Medium Long Extra Long Super Long ANSI Drill Bit Size, dbit (in.) 5/16 5/16 5/16 5/16 5/16 5/16 Minimum Screw Length (in.) 1 1 1/4 1 1/4 1 1/2 1 3/4 2 Screw Size Range No.6 -12 No.6 -12 No.6 -12 No.6 -12 No.6 -12 No.6 -12 Fange Size (in.) 29/64 1/2 1/2 1/2 1/2 1/2 Embed. (Soid Materials) (in.) 5/8 1 1/8 1 1/4 1 3/8 1 1/2 1 3/4   INSTALLATION Drill 5/16" diameter hole through base material. Select the proper size Plastic hollow wall anchor based on the wall thickness. Squeeze the Plastic hollow wall anchor flat and push into the hole. Tap the plastic hollow wall anchor through the wall until the flange is seated flush against the outer wall. Position the fixture, insert the screw through the fixture into the plastic hollow wall anchor, and tighten until it feels secure. Solid base materials – For installations in solid base materials, break off the outer wings. Squeeze the inner wings flat, and insert the Plastic hollow wall anchor into the anchor hole. Insert the screw through the fixture and tighten.

Copyright © cn-anchor.com, All Rights Reserved. Design By hiprovide.com